467571 Replacement Vita Spa Pack by United Spas 110 Volts

Introducing the United Spas C5 Control Series

The beauty of the C5 control series is it’s simplicity. All the components from the relays to the fuses are located right on the board. This is nothing new, except that the C5 series accomplishes this without having high voltage run through the board. With this unique design, you get the convenience of an all-in-one board with the safety and longevity of low power electronics.

The C5 goes a step further. The C5 also incorporates color coded receptacles and wiring so changing the voltage of a component is as easy as moving it’s color coded neutral wire on the power block.

Standard Features:
- Self-Standing Control
- T5 Digital Topside

- Topside Adapter/ Extension Face Plate
- 2 Speed 1st Pump Ready w/Cord
- 1 Speed 2nd Pump Ready
- Circulation Pump Ready
- Blower Ready
- 12v Spa Light Ready w/Cord
- Ozone Ready
- Flo-Thru Stainless Steel Heater

Dimensions:
- 11" Tall
- 19" Wide
- 3.25" Deep

- T5 Topside Dimensions: 5" x 2.5"

- Adapter Face Plate Dimensions: 8-1/4" x 3-3/8"
- The included T5 Topside requires only a 1.75" hole saw to install!

NOTE: These units come standard with the cords for the light and a two speed primary pump, if additional AMP cords are needed please check out the 'Cords and Receptacles' section of the store. If you order them above with the spa control you will save a couple of dollars.

These controls come standard with primary and secondary pumps wired for 240v, light wired for 12v, and all other components (blower, ozone, circulation pump, stereo/aux) wired for 120v. Voltages of these controls may easily be changed by moving the neutral wires at the power block in the control as needed. Also, If you are using a second pump make sure to choose the voltage.

We have include the Topside Extension Plate if you are replacing a larger topside then the T5. Be sure to order a 1/4" Thermowell/Bushing (dry sensor well/housing) if the spa you are installing the control into doesn't already have one installed. You can order at the bottom of this page under related products or in the spa parts category

Safety, built-in

The C5 series of controls are one of the industry’s first controls to be fully tested and approved under the latest editions of UL testing requirements for the United States, and CSA testing requirements for Canada

The T5 Topside control comes standard with every C5 control system sold, and can be programmed for almost any spa's configuration. From a spa with a single pump and light, to a spa with a circulation pump, two booster pumps, air blower, ozonator, fiber optic lighting, and an entertainment system.

Programming the T5 topside is simple and all done using the keypad. The T5 doesn't need a battery to remember it's settings. On-board flash memory makes sure that once a topside is programmed, it stays that way regardless of power status.